Low EMI 4-layer PCB
A 4-layer board for measuring the resistivity of silver nanowires with the four point probe method.
The purpose of this board was to measure the resistivity of silver nanowires using the four point probe method. The method uses four probes in a line: the outer two supply current and the inner two measure the resistance. The nature of the signals being measured meant that the board had to be resistant to electromagnetic interference (EMI).
Because of NDAs, the partial design in Fig. 1 is the only picture I can share.
Design
The following techniques were used to minimize EMI:
- An uninterrupted ground plane as an internal layer
- Signal layers placed close to their return layers, to shorten the return paths
- Power and ground planes close together in the layer stack, to reduce loop inductance
- Decoupling capacitors near vias, to reduce radiation from return paths
- All traces terminated, to avoid resonance issues
- Minimum trace length for critical signals
- Digital and analog signals isolated from one another
- Input and output filters, to reduce high frequency noise to and from the cables
Results
The board was an overall success and survived a very noisy environment. Results measured with it are in the paper linked below.
Papers
- Paper with results measured using this boardNanotechnology (IOP)IOP Science
