← All projects

Transverse flux magnetic gear

A magnetic gear that uses a single permanent magnet, which makes it much simpler to manufacture.

Assembling rotors with dozens of small magnets is difficult, and the price volatility of permanent magnets (PMs) can be quite high. This project designed and optimized a new configuration of magnetic gear that minimizes the use of PMs: the whole gear uses one magnet. If you are new to magnetic gears, this short background may help.

Work

  • Built a detailed electromagnetic FEA model in Ansys Maxwell and optimized the shape and size of the modulators and rotor disks
  • Developed the mechanical design, with 3D printed parts where possible and drawings for the machined parts
  • Characterized the performance with dynamometer tests

The modulator cage, end caps and support structures were 3D printed in PETG. The high-speed, low-speed and modulator rotors were machined out of a soft magnetic composite called Somaloy. The shafts are non-magnetic 300 series stainless steel.

Challenges

The one large magnet produced a huge axial force, which made the mechanical design difficult. Safely attaching the magnet to the rotor and making sure the rotors did not rub the modulators across a 1 mm air gap were the other main problems. The measurements also had a lot of noise.

Results

  • Volumetric torque density of 6.5 kN·m/m³
  • Slip torque of 1.71 N·m
  • Peak efficiency of 83%
  • The FEA model was validated against the prototype results

These numbers are far from groundbreaking. Where this topology excels is that it is much simpler to manufacture and uses one PM, so it could be used in applications where the manufacturing cost is critical. The design would also allow the PM disk to be magnetized after assembly by using dual phase materials, which would simplify assembly further.

Papers

  • Development and Analysis of a Homopolar Consequent Pole Transverse Flux Magnetic GearIEEE IEMDC, 2023IEEE XplorePDF

Some figures on this page are from these papers. © IEEE.